Operating Temperature Range ...........................-40°C to +85°C
Junction Temperature .....................................................+150°C
Storage Temperature Range .............................-65°C to +150°C
Lead Temperature (soldering, 10s) .................................+300°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
CAUTION!
ESD SENSITIVE DEVICE
Part Selection Information
Five different versions are available. The versions differ
by their frequency band of operation, and by the synthe-
sizer’s mode of operation. The MAX2900 has an internal
8-channel synthesizer.
The MAX2901 and MAX2903 are dual-channel versions
with a selectable internal synthesizer division ratio of 62
or 63. The MAX2901 operates in the 902MHz to
928MHz ISM band and the MAX2903 operates in the
867MHz to 870MHz European ISM band.
PART
MAX2900ETI+
MAX2901ETI+
MAX2902ETI+
MAX2903ETI+
MAX2904ETI+
FREQUENCY RANGE (MHz)
902 to 928
902 to 928
902 to 928
867 to 870
867 to 870
The MAX2902 and MAX2904 require an off-chip fre-
quency synthesizer. The MAX2902 operates in the
902MHz– 928MHz ISM band and MAX2904 operates in
the 867MHz–870MHz European ISM band.
The MAX2901–MAX2904 provide LO outputs to drive a
receiver and/or an external synthesizer.
SYNTHESIZER
Internal 8 selectable channels
Internal 2 selectable channels
Off-chip
Internal 2 selectable channels
Off-chip
LO OUTPUTS
No
Yes
Yes
Yes
Yes
DC ELECTRICAL CHARACTERISTICS
(V
CC
= +2.7V to +4.5V, EN = OOKIN = REFEN = high, T
A
= -40°C to +85°C. Typical values are at V
CC
= +4.5V, T
A
= +25°C, unless
otherwise noted.) (Note 1)
PARAMETER
Supply Voltage
Shutdown mode: EN =
REFEN = low
V
CC
= +4.0V
V
CC
= +4.5V
CONDITIONS
MIN
2.7
-3σ
TYP
4.5
0.7
60
32
+3σ
MAX
4.5
10
200
40
UNITS
V
µA
Synth mode: OOKIN = low
(MAX2900/MAX2901/MAX2903 only)
Supply Current
Transmit mode with output
matching optimized for
+23dBm at +4.5V: PWRSET
loaded with 22kΩ resistor
Transmit mode with output
matching optimized for
+20dBm at +3.0V: PWRSET
loaded with 22kΩ resistor
T
A
= -40°C
to +85°C
150
200
mA
T
A
= -40°C
to +85°C
110
135
2
Maxim Integrated
MAX2900–MAX2904
200mW Single-Chip Transmitter ICs for
868MHz/915MHz ISM Bands
DC ELECTRICAL CHARACTERISTICS (continued)
(V
CC
= +2.7V to +4.5V, EN = OOKIN = REFEN = high, T
A
= -40°C to +85°C. Typical values are at V
CC
= +4.5V, T
A
= +25°C, unless
otherwise noted.) (Note 1)
PARAMETER
CONDITIONS
Transmit mode with output
matching optimized for
+17dBm at +3.0V: PWRSET
loaded with 36kΩ resistor
Transmit mode with output
matching optimized for
+14dBm at +3.0V: PWRSET
loaded with 51kΩ resistor
MIN
-3σ
TYP
+3σ
MAX
UNITS
T
A
= +25°C
75
Supply Current (continued)
T
A
= +25°C
57
mA
Reference-only mode: EN = low
PA standby mode: OOKIN = low
(MAX2902/MAX2904 only)
VCO Input Tuning Pin Current
VREG VCO Regulator Voltage
DIGITAL INPUT/OUTPUTS
(PINS EN, REFEN, D0, D1, D2, MODIN, OOKIN, LD)
Input Level High
Input Level Low
Input Bias Current
Output Level High
Output Level Low
Output Current
ANALOG CONTROL INPUTS
(PINS PWRSET, RLPF, VASK)
PWRSET Voltage
RLPF Voltage
VASK Input Impedance
100
-100
-10
V
CC
- 0.4
V
CC
- 0.5V
VTUNE = +4.5V, T
A
= +25°C
2
29
0.02
2.0
3
33
2
µA
V
V
0.5
10
V
µA
V
0.4
100
1.2
1.2
220
400
V
µA
V
V
kΩ
Maxim Integrated
3
MAX2900–MAX2904
200mW Single-Chip Transmitter ICs for
868MHz/915MHz ISM Bands
AC ELECTRICAL CHARACTERISTICS
(MAX290_ EV kits. V
CC
= +2.7V to +4.5V, R
RLPF
= 68kΩ, R
PWRSET
= 22kΩ, f
RF
= 917.28MHz (MAX2900/MAX2901/MAX2902) or f
RF
= 868MHz (MAX2903/MAX2904), VASK = VREG, f
REF
= 14.56MHz (MAX2900/MAX2901/MAX2902) or f
REF
= 13.62MHz
(MAX2903/MAX2904), chip rate on MODIN = 1.22Mbps, P
OUT
= +23dBm, T
A
= -40°C to +85°C. Typical values are at V
CC
= +4.5V,
T
A
= +25°C, unless otherwise noted.) (Note 1)
PARAMETER
ANALOG INPUT PINS
VTUNE Input Capacitance
DIGITAL INPUT PINS
Digital Input Pin Capacitance
VCO AND SYNTHESIZERS SECTION
RFOUT Frequency Range
REFIN Reference Frequency
Range
REFDIV Fixed Reference Divider
Ratio
Main Divider Ratios
PLL Comparison Frequency
VCO Buffer Output Power
REFDIV Fixed Reference
Divider Ratio
VCO Phase Noise
VCO Tuning Gain
VCO Frequency Pulling with
OOK Modulation
PLL Phase Noise
REFOUT Voltage Swing
CPOUT Charge Pump Current
Reference Spurs
Reference Input Voltage for
Nominal Operation
MODIN Frequency Range
Modulation Filter Nominal 3dB
Bandwidth
Modulation Filter Final Attenuation Measured at 30MHz
Carrier Suppression
Noise Power Density
At 960MHz (measured at RFOUT at
+23dBm output power)
28
Using an external frequency reference
200
(MAX2900/MAX2901/MAX2902)
(MAX2903/MAX2904)
(MAX2900/MAX2901/MAX2902)
(MAX2903/MAX2904)
(MAX2900)
Table 4 (MAX2900)
(MAX2901/MAX2903)
(MAX2900)
(MAX2901/MAX2903)
300Ω differential load (MAX2901–MAX2904)
(MAX2901/MAX2903)
At 100kHz offset, measured at RFOUT,
PLL loop BW = 5kHz
(MAX2900/MAX2901/MAX2902)
(MAX2903/MAX2904)
OOKIN clocked at 19kHz, internal (crystal)
or external reference frequency
Measured at RFOUT, 5kHz offset,
PLL loop BW = 50kHz
100
500
-62
300
44
1
902
867
14
13
4
249
62
3.5
13
-12
1
-101
65
85
5
60
-96
86
1
dBc/Hz
MHz/V
kHz RMS
kHz peak
dBc/Hz
mVp-p
µA
dBc
mV
3.64
917.28
868
14.56
13.78
4
928
870
15
14.5
4
256
63
3.75
15
MHz
dBm
MHz
MHz
3
pF
VTUNE = +1.35V
15
pF
CONDITIONS
MIN
-3σ
TYP
+3σ
MAX
UNITS
BPSK, OOK MODULATOR, AND PA
1.2
1
41
28
-150
8
Mb/s
MHz
dB
dB
dBc/Hz
Maxim Integrated
4
MAX2900–MAX2904
200mW Single-Chip Transmitter ICs for
868MHz/915MHz ISM Bands
AC ELECTRICAL CHARACTERISTICS (continued)
(MAX290_ EV kits. V
CC
= +2.7V to +4.5V, R
RLPF
= 68kΩ, R
PWRSET
= 22kΩ, f
RF
= 917.28MHz (MAX2900/MAX2901/MAX2902) or f
RF
= 868MHz (MAX2903/MAX2904), VASK = VREG, f
REF
= 14.56MHz (MAX2900/MAX2901/MAX2902) or f
REF
= 13.62MHz
(MAX2903/MAX2904), chip rate on MODIN = 1.22Mbps, P
OUT
= +23dBm, T
A
= -40°C to +85°C. Typical values are at V
CC
= +4.5V,
T
A
= +25°C, unless otherwise noted.) (Note 1)
PARAMETER
CONDITIONS
PWRSET = 22kΩ, V
CC
= +4.5V,
T
A
= +25°C
RF Output Power
PWRSET = 22kΩ, V
CC
= +4.5V,
T
A
= -40°C to +85°C
PWRSET = 22kΩ, V
CC
= +3.0V, T
A
= +25°C
RF Output Power Flatness
Adjacent Channel Power Ratio
Alternate Channel Power Ratio
OOK Control Range
ASK Output Power Adjustment
Range
RFOUT Rise and Fall Time
ASK output power back-
off relative to max power
OOKIN = high,
VASK = 0
OOKIN = high,
VASK = 1V
f
RF
= 900MHz to 930MHz
(MAX2900/MAX2901/MAX2902)
f
RF
= 867MHz to 870MHz
PN sequence at 1.22MHz
PN sequence at 1.22MHz
40
MIN
-3σ
21
20.5
18
20
0.3
0.1
-17
-26
80
41
dB
16
1
-50
-51
-63
dBc
< -70
µs
dBc
dBc
dB
TYP
23.5
+3σ
25
25
21
dB
dBm
MAX
UNITS
Square-wave signal applied on OOK
At 2nd harmonic of RF output frequency
with external matching network
At 3rd harmonic of RF output frequency
with external matching network
At 4th harmonic of RF output frequency
with external matching network
Out of 902MHz to 928MHz band other than
harmonics with external matching network
(MAX2900/MAX2901/MAX2902)
Out of 867MHz to 870MHz band other than
harmonics with external matching network
(MAX2903/MAX2904)
Spurious Emissions
< -70
Unlocked, Out-of-Band Spurious
Output Level
Any condition when synthesizer unlocked
(pin LD low)
Modulation off, measured at 960MHz, any
gain setting (MAX2900/MAX2901/MAX2902)
< -50
-126
-126
2:1
2:1
-120
dBm
Noise Level Out of Band
Modulation off, measured at 900MHz, any
gain setting (MAX2903/MAX2904)
Output VSWR for Guaranteed
Stability
Maximum Allowable Output VSWR
-120
dBm/Hz
Note 1:
Devices are production tested at T
A
= +25°C and +85°C. Min/Max values are guaranteed by design and characterization
中风发生时，一切都是以秒来计算的。延误治疗可能导致大脑重大损伤。伦敦大学医学院的一位博士Alistair McEwan已经获得行为医学研究所(Action Medical Research)的同意，为急救人员开发一种无线诊断系统来减少时间延误。感谢抗血栓药物，一些病人在病情发作的三个小时之内可以完全恢复。但出血也会导致中风。医生在治疗之前需要确定发病原因，因为不适当的服用抗血栓药物会加重损害。...[详细]
SynQor推出超小的病人全接触型400W医疗电源模块，该电源模块的封装为3×5×1.44，功率密度高达18.3W/立方英寸，转换效率达91%。 SynQor通过推出首款专门针对医疗应用而研制的AC/DC电源模块，使得公司的多元化战略持续成功地延伸至新的医疗领域。ACuQor模块系列实现了在3×5×1.44有限尺寸上提供400W的有用功率。SynQor可以提供48V，36V or 24V的...[详细]
51单片机
京公网安备 11010802033920号
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved
电子工程世界
