Datasheet> 器件分类 > 模拟混合信号IC> 信号电路> LTC5530ES6#TR

文档预览

LTC5530ES6#TR: 产品描述IC RF pwr detector prec tsot23-6; 产品类别模拟混合信号IC 信号电路; 文件大小341KB，共3页; 制造商Linear ( ADI ); 官网地址http://www.analog.com/cn/index.html

下载文档详细参数选型对比全文预览

LTC5530ES6#TR概述

IC RF pwr detector prec tsot23-6

LTC5530ES6#TR规格参数

参数名称	属性值
Brand Name	Linear Technology
是否Rohs认证	不符合
厂商名称	Linear ( ADI )
零件包装代码	SOT
包装说明	VSSOP,
针数	6
制造商包装代码	S6
Reach Compliance Code	not_compliant
ECCN代码	EAR99
模拟集成电路 - 其他类型	ANALOG CIRCUIT
JESD-30 代码	R-PDSO-G6
JESD-609代码	e0
长度	2.9 mm
湿度敏感等级	1
功能数量	1
端子数量	6
最高工作温度	85 °C
最低工作温度	-40 °C
封装主体材料	PLASTIC/EPOXY
封装代码	VSSOP
封装形状	RECTANGULAR
封装形式	SMALL OUTLINE, VERY THIN PROFILE, SHRINK PITCH
峰值回流温度（摄氏度）	235
认证状态	Not Qualified
座面最大高度	1 mm
最大供电电压 (Vsup)	6 V
最小供电电压 (Vsup)	2.7 V
标称供电电压 (Vsup)	3.6 V
表面贴装	YES
温度等级	INDUSTRIAL
端子面层	Tin/Lead (Sn/Pb)
端子形式	GULL WING
端子节距	0.95 mm
端子位置	DUAL
处于峰值回流温度下的最长时间	20
宽度	1.625 mm

文档预览

下载PDF文档

全文
预览

QUICK START GUIDE FOR DEMONSTRATION CIRCUIT 715

RF POWER DETECTOR 300 MHZ TO 7000MHZ

LTC5530ES6

DESCRIPTION

Demonstration circuit 715 is used to evaluate the

LTC®5530ES6, RF power detector with integrated out-

put buffer and voltage reference. The LTC5530ES6 has

provisions for enable and gain adjustments. The

LTC5530ES6 converts an RF input signal at pin 1 (RFin)

to a DC voltage at pin 5 (Vout). The RF input frequency

range is 300 MHz to 7000 MHz. Maximum input power

is 10 dBm. The output voltage at Vout will start at an

initial DC value of typically 120 mV +/- 35 mV. When the

RF signal is applied, the output voltage will increase.

The optional R1 termination resistor and C3 output

shunt capacitor are not placed on the PCB. R3 and R4

are 10k ohm resistors. This corresponds to the gain set-

ting = 2. The demo circuit has R2, a 22K pull-up resistor,

which provides a logic HIGH for the Enable pin (IC En-

abled). Enable pin E3 should be left unconnected for ini-

tial tests and measurements.

Design files for this circuit board are available. Call

the LTC factory.

LTC is a trademark of Linear Technology Corporation

QUICK START PROCEDURE

Demonstration circuit 715 is easily set up for evaluating

the LTC5530ES6 RF power detector performance. Follow

the procedures outlined below and connections on the

attached diagram for proper operation.

1. Connect the input DC power supply (2.7V to 6V) to

E1. Connect the power supply ground to E4 or E5.

Connect J1 to the RF signal generator via coaxial ca-

ble with an SMA connector. It is common practice to

include a 2dB or 3dB pad to minimize reflections

back into the signal generator.

2. Apply an RF input signal and measure the Vout DC

voltage at E2.

3. Connect E3 (Enable pin) to ground. The IC is in

shutdown mode.

Optional measurements can be done by changing the R3

resistor from 10k ohm to a higher value to increase the

gain of the part, if desired.

LTC5530ES6#TR相似产品对比

	LTC5530ES6#TR	DC715A	LTC5530ES6#TRPBF	LTC5530ES6#TRM	LTC5530ES6#TRMPBF
描述	IC RF pwr detector prec tsot23-6	eval board for ltc5530es6	IC RF pwr detector prec tsot23-6	IC RF pwr detector prec tsot23-6	IC RF PWR DETECTOR PREC TSOT23-6
Brand Name	Linear Technology	-	Linear Technology	Linear Technology	Linear Technology
是否Rohs认证	不符合	-	符合	不符合	符合
厂商名称	Linear ( ADI )	-	Linear ( ADI )	Linear ( ADI )	Linear ( ADI )
零件包装代码	SOT	-	SOT	SOT	SOT
包装说明	VSSOP,	-	VSSOP,	VSSOP,	VSSOP,
针数	6	-	6	6	6
制造商包装代码	S6	-	S6	S6	S6
Reach Compliance Code	not_compliant	-	compliant	not_compliant	compliant
ECCN代码	EAR99	-	EAR99	EAR99	EAR99
模拟集成电路 - 其他类型	ANALOG CIRCUIT	-	ANALOG CIRCUIT	ANALOG CIRCUIT	ANALOG CIRCUIT
JESD-30 代码	R-PDSO-G6	-	R-PDSO-G6	R-PDSO-G6	R-PDSO-G6
JESD-609代码	e0	-	e3	e0	e3
长度	2.9 mm	-	2.9 mm	2.9 mm	2.9 mm
湿度敏感等级	1	-	1	1	1
功能数量	1	-	1	1	1
端子数量	6	-	6	6	6
最高工作温度	85 °C	-	85 °C	85 °C	85 °C
最低工作温度	-40 °C	-	-40 °C	-40 °C	-40 °C
封装主体材料	PLASTIC/EPOXY	-	PLASTIC/EPOXY	PLASTIC/EPOXY	PLASTIC/EPOXY
封装代码	VSSOP	-	VSSOP	VSSOP	VSSOP
封装形状	RECTANGULAR	-	RECTANGULAR	RECTANGULAR	RECTANGULAR
封装形式	SMALL OUTLINE, VERY THIN PROFILE, SHRINK PITCH	-	SMALL OUTLINE, VERY THIN PROFILE, SHRINK PITCH	SMALL OUTLINE, VERY THIN PROFILE, SHRINK PITCH	SMALL OUTLINE, VERY THIN PROFILE, SHRINK PITCH
峰值回流温度（摄氏度）	235	-	260	235	260
认证状态	Not Qualified	-	Not Qualified	Not Qualified	Not Qualified
座面最大高度	1 mm	-	1 mm	1 mm	1 mm
最大供电电压 (Vsup)	6 V	-	6 V	6 V	6 V
最小供电电压 (Vsup)	2.7 V	-	2.7 V	2.7 V	2.7 V
标称供电电压 (Vsup)	3.6 V	-	3.6 V	3.6 V	3.6 V
表面贴装	YES	-	YES	YES	YES
温度等级	INDUSTRIAL	-	INDUSTRIAL	INDUSTRIAL	INDUSTRIAL
端子面层	Tin/Lead (Sn/Pb)	-	Matte Tin (Sn)	Tin/Lead (Sn/Pb)	Matte Tin (Sn)
端子形式	GULL WING	-	GULL WING	GULL WING	GULL WING
端子节距	0.95 mm	-	0.95 mm	0.95 mm	0.95 mm
端子位置	DUAL	-	DUAL	DUAL	DUAL
处于峰值回流温度下的最长时间	20	-	30	20	30
宽度	1.625 mm	-	1.625 mm	1.625 mm	1.625 mm

LTC5530ES6#TR

LTC5530ES6#TR概述

LTC5530ES6#TR规格参数

文档预览

LTC5530ES6#TR相似产品对比

推荐资源