www.neophotonics.com
VER000/ 051308
PTD5061-5XXX(+)
2.5Gbps DWDM SFP Transceiver
1
1.1
Features
Transceiver unit with independent
DWDM DFB laser diode transmitter
APD photodiode receiver
1.2
1.3
1.4
1.5
1.6
1.7
1.8
1.9
Compliant with DWDM SFP MSA
Compliant with SFP MSA with duplex LC receptacle
Digital diagnostic monitoring
Internal Calibration of DDM
Hot-pluggable
Metal enclosure for lower EMI
+3.3V Single power supply
Up to 2.7Gb/s data rate
1.10 100GHz ITU Grid, C Band or L Band
1.11 Wavelength controlled within ± 0.1nm over life and temperature
1.12 LVPECL logic interface simplifies interface to external circuitry
1.13 LVTTL logic level RX LOS
1.14 With pull de-latch
1.15 3200ps/nm Dispersion (160km) ITU Standard Fiber
1.16 Complies with RoHS directive (2002/95/EC)
2
2.1
Applications
C Band or L Band DWDM networks
3
General
The optical transceiver is compliant with the Small Form-factor Pluggable (SFP) Transceiver MultiSource
Agreement (MSA) and DWDM SFP MSA. It offer a simple and convenient way to interface PCBs to
single mode fiber optic cables in Dense Wavelength Division Multiplexing (DWDM) applications. It is a
high performance, cost effective module for serial optical data communication applications.
1 of 13
NeoPhotonics Corporation
2911 Zanker Road
San Jose, CA 95134, USA
Tel: 408.232.9200 Fax: 408.456.2971
Email: sales@neophotonics.com
NeoPhotonics China
PHOTON BLD, 12th South Keji Rd. South Hi-Tech Industrial Park,
Shenzhen, China
P.C.: 518057
Tel: +86 755 26748283(7)
Fax: +86 755 26748186
Email: sales@neophotonics.com.cn
PTD5061-5XXX(+)
2.5Gbps DWDM SFP Transceiver
APD Bias Control Circuit
RD+/-
LOS
TD+/-
TxDis
TxFault
Post Amp
APDTIA
LD Driver
Ib
Pi
Po
WL
LD
TEC
Temp
Itec
Vcc
SDA
SCL
A/D convertor
Digital Diagnostic
Monitoring Interface
EEPROM
Memory
3.1
Transmitter Section
Transmitter is designed for single mode fiber and operates at DWDM wavelength of C Band or L Band.
The transmitter module uses a DFB laser diode and full IEC825 and CDRH class 1 eye safety. The
output power can be disabled via the single TX Disable pin. Logic LVTTL HIGH level disables the
transmitter. It contains APC function, TEC function, temperature compensation circuit, PECL data inputs,
LVTTL TX Disable input and TX Fault output interface.
3.2
Receiver Section
The
The receiver section uses a hermetic packaged front end receiver (APD and preamplifier).
postamplifier is AC coupled to preamplifier through a capacitor and a low pass filter. The capacitor and
LPF are enough to pass the signal from 5Mb/s to 2670Mb/s without significant distortion or performance
penalty. The LPF limits the preamplifier bandwidth to improve receiver sensitivity. As the input optical is
decreased, LOS will switch from low to high. As the input optical power is increased from very low levels,
LOS will switch back from high to low.
3.3
EEPROM Section
The optical transceiver contains an EEPROM. It provides access to sophisticated identification
information that describes the transceiver’s capabilities, standard interfaces, manufacturer, and other
information.
The serial interface uses the 2-wire serial CMOS EEPROM protocol defined for the ATMEL
AT24C01A/02/04 family of components. When the serial protocol is activated, the host generates the
serial clock signal (SCL, Mod Def 1). The positive edge clocks data into those segments of the EEPROM
2 of 13
NeoPhotonics Corporation
2911 Zanker Road
San Jose, CA 95134, USA
Tel: 408.232.9200 Fax: 408.456.2971
Email: sales@neophotonics.com
NeoPhotonics China
PHOTON BLD, 12th South Keji Rd. South Hi-Tech Industrial Park,
Shenzhen, China
P.C.: 518057
Tel: +86 755 26748283(7)
Fax: +86 755 26748186
Email: sales@neophotonics.com.cn
PTD5061-5XXX(+)
2.5Gbps DWDM SFP Transceiver
that are not write protected within the SFP transceiver. The negative edge clocks data from the SFP
transceiver. The serial data signal (SDA, Mod Def 2) is bi-directional for serial data transfer. The host
uses SDA in conjunction with SCL to mark the start and end of serial protocol activation. The memories
are organized as a series of 8-bit data words that can be addressed individually or sequentially.
The Module provides diagnostic information about the present operating conditions. The transceiver
generates this diagnostic data by digitization of internal analog signals. Alarm/warning threshold data is
written during device manufacture. TEC current monitoring, laser temperature monitoring, received
power monitoring, transmitted power monitoring, bias current monitoring, supply voltage monitoring and
transceiver temperature monitoring all are implemented. The diagnostic data are internal calibration and
stored in memory locations 96 – 109 at wire serial bus address A2h. The transceiver memory map
specific data field defines as following.
0
2 wire address
1010000X (A0h)
Serial ID Defined by
DWDM SFP MSA
(96 bytes)
0
55
95
2 wire address
1010001X (A2h)
Alarm and Warning
Thresholds (56 bytes)
0 for DWDM SFP
(40 bytes)
Real Time Diagnostic
Interface (24 bytes)
Vendor Specific (7 bytes)
Table Select Byte
95
Vendor Specific
(32 bytes)
119
126
127
128
Reserved
(128 bytes)
127
128
247
255
User Writable
EEPROM (120 bytes)
Vendor Specific (8 bytes)
Table 00h/01h
DWDM SFP
Control
Functions
Table 02
Reserved
Table
03h-7Fh
Vendor
Specific
Table
80h-FFh
255
4
4.1
Performance Specifications
Absolute Maximum Ratings
Parameter
Symbol
T
stg
T
C
-
V
cc
-V
ee
Min.
-40
-5
GND
-0.5
Max.
+85
+70
V
cc
+3.6
Unit
°C
°C
V
V
Storage Temperature (Non-operating)
Case Temperature (Operating)
Input Voltage
Power Supply Voltage
3 of 13
NeoPhotonics Corporation
2911 Zanker Road
San Jose, CA 95134, USA
Tel: 408.232.9200 Fax: 408.456.2971
Email: sales@neophotonics.com
NeoPhotonics China
PHOTON BLD, 12th South Keji Rd. South Hi-Tech Industrial Park,
Shenzhen, China
P.C.: 518057
Tel: +86 755 26748283(7)
Fax: +86 755 26748186
Email: sales@neophotonics.com.cn
PTD5061-5XXX(+)
2.5Gbps DWDM SFP Transceiver
4.2
Recommended Operating Conditions
Parameter
Symbol
V
cc
I
cc
T
C
-
Min.
3.13
-
-5
-
Typ.
3.30
-
-
2.5
Max.
3.50
500
+70
-
Unit
V
mA
°C
Gb/s
Note
-
1
-
-
Power Supply Voltage
Power Supply Current
Case Temperature (Operating)
Data Rate
4.3
Transmitter E-O Characteristics
Parameter
Center Wavelength Spacing
Center Wavelength
Spectral Width (-20dB)
Side Mode Suppression Ratio
Maximum dispersion
Average Optical Output Power
Extinction Ratio
Transmitter Enable Voltage
Transmitter Disable Voltage
Single Ended Data Input Swing
Output Eye Diagram
4.4
Receiver O-E Characteristics
Parameter
Operate Wavelength
Sensitivity
Saturation
LOS Asserted
LOS De-Asserted
LOS Hysteresis
Single Ended Data Output Swing
LOS Low Voltage
LOS High Voltage
Reflectance
Notes:
Symbol
-
λ
Δλ
SMSR
-
Po
Er
VEN
VD
V
INPP
Min.
-
X-100
-
30
-
3
8.2
0
2.0
250
Typ.
100
X
-
-
-
-
-
-
-
-
Max.
-
X+100
0.3
-
3200
8
-
0.8
Vcc
1200
Unit
GHz
pm
nm
dB
ps/nm
dBm
dB
V
V
mV
Note
-
2
-
-
-
-
-
-
-
Compliant with ITU recommendation G957
Symbol
-
S
en
P
sat
-
-
-
V
OUTPP
VLout
VHout
Min.
1520
-
-9
-46
-
-
300
-
2.0
Typ.
-
-31
-
-
-
1.5
-
-
-
Max.
1611
-28
-
-
-28
-
1000
0.8
-
Unit
nm
dBm
dBm
dBm
dBm
dB
mV
V
V
Note
-
3
3
High
level:
Alarm
-
-
-
-
-
-
-27
dB
-
1. The current excludes the output load current.
2. X = specified ITU center wavelength. (To See “Ordering Information”)
3. Sensitivity and Saturation levels for a 2
23
-1 PRBS with 72 ones and 72 zeros inserted.
4 of 13
NeoPhotonics Corporation
2911 Zanker Road
San Jose, CA 95134, USA
Tel: 408.232.9200 Fax: 408.456.2971
Email: sales@neophotonics.com
NeoPhotonics China
PHOTON BLD, 12th South Keji Rd. South Hi-Tech Industrial Park,
Shenzhen, China
P.C.: 518057
Tel: +86 755 26748283(7)
Fax: +86 755 26748186
Email: sales@neophotonics.com.cn
PTD5061-5XXX(+)
2.5Gbps DWDM SFP Transceiver
5
5.1
EEPROM Section
Serial ID：Data Fields-Address A0
Name
Addr.
0
1
2
Size(bytes)
field
1
1
1
Identifier
Ext. Identifier
Connector
0B
24
07
00
0C
00
3-10
8
Transceiver
Codes
02
80
10
01
05
11
12
13
1
1
1
Encoding
BR, Nominal
Reserved
05
19
00
DWDM SFP
DWDM,Power:1w~1.5w,Class of temp:[-5℃-70℃]
LC connector
Reserved
OC-48 long reach，SONET LR-2
-
1000BASE-LX
very long distance (V)
Longwave laser(LL)
Single mode
100/200Mbytes/sec compliant
SONET scrambled
of
Vaule(Hex)
Description
2500Mb/s
-
Link length supported for
14
1
Length
A0
9/125
μ
m
fiber, 160km.
15
16
17
18
1
1
1
1
Max Temp
Min Temp
Max Supply
Current
Reserved
Channel
46
FB
7D
00
Maximum operating case temperature is 70℃
Minimum operating case temperature is -5℃
Maximum Supply Current is 500mA
-
Channel Spacing 100GHZ,and Number of
19
1
Spacing and
Tuning
41
channels is one(not tunable)
4E 45
4F 50
48 4F
20-35
16
Vendor
Name
54 4F
4E 49
43 53
20 20
20 20
36
1
Option Features
00
Wavelength monitor type in A2 byte106-107 is
laser wavelength
“NEOPHOTONICS” (ASCII)
5 of 13
NeoPhotonics Corporation
2911 Zanker Road
San Jose, CA 95134, USA
Tel: 408.232.9200 Fax: 408.456.2971
Email: sales@neophotonics.com
NeoPhotonics China
PHOTON BLD, 12th South Keji Rd. South Hi-Tech Industrial Park,
Shenzhen, China
P.C.: 518057
Tel: +86 755 26748283(7)
Fax: +86 755 26748186
Email: sales@neophotonics.com.cn
嵌入式系统
京公网安备 11010802033920号
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved
电子工程世界
