C400 mSATA NAND Flash SSD
Features
C400 mSATA NAND Flash SSD
MTFDDAT128MAM, MTFDDAT256MAM
Features
•
•
•
•
Micron
®
25nm MLC NAND Flash
RoHS-compliant package
SATA 6 Gb/s interface
ATA modes supported
– PIO mode 3, 4
– Multiword DMA mode 0, 1, 2
– Ultra DMA mode 0, 1, 2, 3, 4, 5
Industry-standard, 512-byte sector size support
Native command queuing support with 32-com-
mand slot support
ATA-8 ACS2 command set compliant
ATA security feature command set and password
login support
Secure erase (data page) command set: fast and se-
cure erase
Self-monitoring, analysis, and reporting technology
(SMART) command set
Performance
1, 2
– Sequential 128k READ: up to 500 MB/s
– Sequential 128k WRITE: up to 260 MB/s
– Random 4k READ: up to 45,000 IOPS
– Random 4k WRITE: up to 50,000 IOPS
– PCMark
®
Vantage (HDD test suite score): up to
75,000
– READ/WRITE latency: 55µs (TYP)
• Reliability
– MTTF: 1.2 million device hours
3
– Static and dynamic wear leveling
– Uncorrectable bit error rate (UBER): <1 sector
per 10
15
bits read
• Low power consumption
– <200mW TYP
4
• Endurance: Total bytes written (TBW) – 72TB
• Capacity
5
(unformatted): 128GB, 256GB
• Mechanical – 5mm height
– mSATA connector: 3.3V ±5%
– Caseless design: 50.80mm x 29.85mm x 3.75mm
– Weight: 10g (MAX)
• Field-updateable firmware
• Operating temperature
– Commercial (0°C to +70°C)
6
Notes:
1. Typical I/O performance numbers as meas-
ured using Iometer with a queue depth of
32 and write cache enabled.
2. 4K transfers used for READ/WRITE latency
values.
3. The product achieves a mean time to failure
(MTTF) based on population statistics not
relevant to individual units.
4. Active power measured during execution of
MobileMark
®
2007 with DIPM (device-initi-
ated power management) enabled.
5. 1GB = 1 billion bytes; formatted capacity is
less.
6. Drive case temperature.
•
•
•
•
•
•
•
Warranty:
Contact your Micron sales representative
for further information regarding the product,
including product warranties.
PDF: 09005aef8484bfff
realssd_c400_msata.pdf - Rev. D 8/12 EN
1
Products and specifications discussed herein are subject to change by Micron without notice.
Micron Technology, Inc. reserves the right to change products or specifications without notice.
©
2011 Micron Technology, Inc. All rights reserved.
C400 mSATA NAND Flash SSD
Features
Part Numbering Information
Micron’s RealSSD™ C400 SSD is available in different configurations and densities. Visit
www.micron.com
for a
list of valid part numbers.
Figure 1: Part Number Chart
MT FD
Micron Technology
Product Family
FD = Flash drive
D
AT xxx M AM - 1
K
x
x
xx
ES
Production Status
Blank = Production
ES = Engineering sample
Operating Temperature Range
Drive Interface
D = SATA 6.0 Gb/s
Hardware Feature Set
Blank = Commercial (0°C to +70°C)
Drive Form Factor
AT = mSATA
Blank = Null
AA = Contact factory
AB = Contact factory
AC = Contact factory
Drive Density
128 = 128GB
256 = 256GB
Firmware Feature Set
Blank = Null
1 = Contact factory
2 = Contact factory
NAND Flash Type
M = MLC
Product Family
AM = C400
BOM Revision
For example:
1 = 1st generation
Sector Size
1 = 512-byte
NAND Flash Component
J = 32Gb, MLC, x8, 3.3V (25nm)
K = 64Gb, MLC, x8, 3.3V (25nm)
PDF: 09005aef8484bfff
realssd_c400_msata.pdf - Rev. D 8/12 EN
2
Micron Technology, Inc. reserves the right to change products or specifications without notice.
©
2011 Micron Technology, Inc. All rights reserved.
C400 mSATA NAND Flash SSD
General Description
General Description
Micron’s RealSSD solid state drive (SSD) uses a single-chip controller with a SATA inter-
face on the system side and n-channels of Micron NAND Flash internally. Packaged in
an JEDEC-standard mSATA form factor, the SSD integrates easily in existing storage in-
frastructures.
The SSD is designed to use the SATA interface efficiently during both READs and
WRITEs while delivering bandwidth-focused performance. SSD technology enables en-
hanced boot times, faster application load times, reduced power consumption, and ex-
tended reliability.
Figure 2: Functional Block Diagram
NAND
SATA
SSD
controller
NAND
NAND
NAND
NAND
DRAM
buffer
PDF: 09005aef8484bfff
realssd_c400_msata.pdf - Rev. D 8/12 EN
3
Micron Technology, Inc. reserves the right to change products or specifications without notice.
©
2011 Micron Technology, Inc. All rights reserved.
C400 mSATA NAND Flash SSD
Logical Block Address Configuration
Logical Block Address Configuration
The drive is set to report the number of logical block addresses (LBA) that will ensure
sufficient storage space for the specified density. Standard LBA settings, based on the
IDEMA standard (LBA1-02), are shown below.
Table 1: Standard LBA Settings
Total LBA
Drive Size
128GB
256GB
Decimal
250,069,680
500,118,192
Hexadecimal
EE7C2B0
1DCF32B0
Decimal
250,069,679
500,118,191
Max LBA
Hexadecimal
EE7C2AF
1DCF32AF
User Available Bytes
(Unformatted)
128,035,676,160
256,186,209,271
Physical Configuration
Table 2: mSATA Dimensions and Weight
Value
Width
Length
Unit weight
Height
29.85
50.80
10
3.75
Unit
mm (NOM)
mm (NOM)
g (MAX)
mm (MAX)
PDF: 09005aef8484bfff
realssd_c400_msata.pdf - Rev. D 8/12 EN
4
Micron Technology, Inc. reserves the right to change products or specifications without notice.
©
2011 Micron Technology, Inc. All rights reserved.
ADI 工业技术
京公网安备 11010802033920号
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved
电子工程世界
