WLS1A00AQ3BT3,WLS1A00AQ3BT3 pdf中文资料,WLS1A00AQ3BT3引脚图,WLS1A00AQ3BT3电路-Datasheet-电子工程世界

Datasheet> 器件分类 > WLS1A00AQ3BT3

文档预览

WLS1A00AQ3BT3: 产品描述Limitlessâ¢ Single Switch Adapter; 文件大小2MB，共47页; 制造商Honeywell; 官网地址http://www.ssec.honeywell.com/

下载文档全文预览

WLS1A00AQ3BT3概述

Limitlessâ¢ Single Switch Adapter

文档预览

下载PDF文档

全文
预览

Installation and Technical Manual for the

Limitless™ Series WDRR Receiver

50063987

ISSUE 5

WARNING

•

DO NOT USE these products as safety or emergency

stop devices or in any other application where failure of

the product could result in personal injury.

Failure to comply with these instructions could result in

death or serious injury.

PERSONAL INJURY

•

The WDRR must be installed in accordance with the

requirements specified in this document in order to comply

with the specific Country Communication Agency

requirements. (i.e. FCC, IC, ETSI, ACMA, etc.) See

Section 3 as it requires choosing the correct Country Use

Code and thus allowable antenna and/or cable usage.

WARNING

Honeywell does not recommend using devices for critical

control applications where there is, or may be, a single point

of failure or where single points of failure may result in an

unsafe condition. It is up to the end-user to weigh the risks

and benefits to determine if the products are appropriate for

the application based on security, safety and performance.

Additionally, it is up to the end-user to ensure that the

control strategy results in a safe operating condition if any

crucial segment of the control solution fails.

Honeywell customers assume full responsibility for learning

and meeting the required Declaration of Conformity,

Regulations, Guidelines, etc. for each country in their

distribution market.

Failure to comply with these instructions could result in

death or serious injury.

•

Pay attention to ESD discharge at dc-in port.

WARNING

•

Korean Communication Commission does not allow this

equipment to be used for rescue service.

•

Anatel states that this device works as a secondary

function model. It may not be used as a protection device

against harmful interference. It cannot cause interference

with systems that are running as primary function.

WARNING

CAUTION

* Power to the WDRR should not be applied during

installation of antenna as damage could occur to the

WDRR electronics.

WARNING

•

To satisfy FCC RF exposure requirements for mobile

transmitting devices, a separation distance of 20 cm or

more should be maintained between the antenna of this

device and persons during device operation To ensure

compliance, operation at closer than this distance is not

recommended. The antenna used for this transmission

must not be co-located in conjunction with any other

antenna or transmitter.

Failure to comply with these instructions could result in

death or serious injury.

RF EXPOSURE

CAUTION

* The WDRR receiver offers optimal performance when

paired with Limitless™ inputs that have a firmware

version of 7170 or a greater number (i.e., FW7170 will be

printed on the Limitless™ input label). If the Limitless™

input is paired with older firmware (FW7170 or a lesser

number), the WDRR may exhibit delayed responses

under simultaneous operation.

Sensing and Productivity Solutions

Limitless™

WDRR Receiver

IST OF

IGURES

Issue 5

50063987

Figure 1. European Declaration of Conformity (DoC)

.................................................................................................. 9

Figure 2. Limitless™ WDRR DIN Rail Receiver with location call-out

....................................................................... 12

Figure 3. Limitless™ WDRR DIN Rail Receiver with WDRRPWRASM connected

................................................... 13

Figure 4. Limitless™ Switch Housing

........................................................................................................................ 20

Figure 5. Limitless™ WDRR Housing

........................................................................................................................ 20

Figure 6. Limitless™ Switch with Function Button Depressed

.................................................................................. 20

Figure 7. Limitless™ Switch Label Placement

........................................................................................................... 20

Figure 8. Limitless™ WDRR Operation and LED Functions Chart

............................................................................ 22

Figure 9. Radiation Pattern of an Omni-directional Antenna

..................................................................................... 25

Figure 10. Limitless™ switch to WDRR Antennas with RF Signal Line of Sight (LOS) Free From Obstacles

......... 26

Figure 11. Limitless™ switch to WDRR Antennas with RF Signal Line of Sight (LOS) Affected by

......................... 26

Figure 12. Limitless™ WDRR RP-SMA Connection, Integral

.................................................................................... 28

Figure 13. Limitless™ WDRR RP-SMA Connection, Remote

................................................................................... 28

Figure 14. Straight, Right-Angle, and Tilt-and-Swivel antennas

................................................................................ 28

Figure 15. Adhesive Mount Antenna – Step 1. Pre-clean the surface

...................................................................... 29

Figure 16. Adhesive Mount Antenna – Step 2. Peel Protection from Adhesive Strip................................................

Figure 17. Adhesive Mount Antenna – Step 3. Mount the Antenna...........................................................................

Figure 18. Mast Mount Antenna – Tighten nut on mounting bracket

...................................................................... 30

Figure 19. Mast Mount Antenna – Side View with Attachment to Pipe

.................................................................. 30

Figure 20. Magnetic Mount Base with Antenna – Mounted on Steel Surface

.......................................................... 31

Figure 21. WAN09RSP Magnetic Mount Antenna

..................................................................................................... 31

Figure 22. WAN10RSP Magnetic Mount Antenna

..................................................................................................... 31

Figure 23. Through-hole mount antenna

.................................................................................................................... 31

Figure 24. Highest RF signal when antennas are as parallel to each other as possible (parallel arrangement

shown with the Limitless™ WPMM monitor and WGLA switch)

................................................................................ 32

Figure 25. Limitless™ WDRR Mounting Clips

........................................................................................................... 35

Figure 26. Limitless™ WDRR Mounting Tabs

............................................................................................................ 35

IST OF

ABLES

Table 1 –Table of Abbreviations and Definitions

.......................................................................................................... 2

Table 2 –Table Symbol Definitions

............................................................................................................................... 3

Table 3 – North America; Country Use Code “A”

........................................................................................................ 4

Table 4 – Asia Pacific; Country Use Code “B”

............................................................................................................ 4

Table 5 – European Union; Country Use Code “B”

..................................................................................................... 4

Table 6 – Other European Countries; Country Use Code “B”

..................................................................................... 4

Table 7 – Approvals and Ratings

................................................................................................................................. 5

Table 8 – Radio Module Specifications

....................................................................................................................... 5

Table 9 – Electrical Specifications

............................................................................................................................... 5

Table 10 – Environmental Specifications

..................................................................................................................... 6

Table 11 – Country Use Code A Antenna Options

..................................................................................................... 10

Table 12 – Country Use Code B Antenna Options.....................................................................................................

sensing.honeywell.com

WLS1A00AQ3BT3

WLS1A00AQ3BT3概述

文档预览

推荐资源