Custom performance characteristics are available upon request. Use form C052 to detail
non-standard parameters.
Contact your local CTS Representative or CTS Customer Service for assistance.
* Prior to 11/7/06 the part number format did not contain this designator. These "Old Format" numbers (008-0261-0 Rev. E) are still valid with frequencies less than
or equal to 48.0000 MHz as Fundamental Mode designs. Frequencies above 48.0000 MHz will be Third Overtone designs. Refer to PCM-1211 for more details.
Document No. 008-0261-0
Page 1 - 3
Rev. F
٠ ٠ ٠
CTS Electronic Components, Inc.
٠
171 Covington Drive
٠
Bloomingdale, IL 60108
٠ ٠ ٠
٠ ٠ ٠
www.ctscorp.com
٠ ٠ ٠
7.0x5.0mm Low Cost
Surface Mount Crystal
Model 407
ELECTRICAL CHARACTERISTICS
PARAMETER
Operating Mode
(Note 1)
Crystal Cut
Frequency Range
Frequency Tolerance @ 25°C
Electrical Parameters
VALUE
Fundamental or 3
RD
Overtone
AT-Cut
8.0 MHz to 100.0 MHz
± 30 ppm Standard
(± 10 ppm and ± 20 ppm Available)
Frequency Stability Tolerance
(Operating Temperature Range, Referenced to 25°C Reading)
便携式医疗设备的特殊性决定了它们应该是对用户友好的、必须工作在无菌环境下,并且空间占用小、耗能低。 同时,便携式医疗设备还需要足够的计算能力以便处理医疗数据,能够连接到无线或有线接口以便记录和发送数据。从设计人员的角度考虑,上述需求需要低功耗的单片机(MCU)和数字信号控制器(Digital Signal Controller,DSC)。 正是有了嵌入式处理器,设计人员才有可能设...[详细]
Yamaha Motor Group旗下的i-PULSE有限公司日前已与华尔莱科技(Valor)结为合作伙伴关系,基于Valor的vPlan生产规划工具向i-PULSE组装设备的使用者提供完整的从设计到制造的NPI解决方案。在近期日本东京举办的Protec展会(6/11-6/13)上,i-PULSE首度展出了该新产品并将直接向其客户进行销售。 新产品的名称为“iPlan”,它将提供一系...[详细]