EX-420
Evacuated Miniature Crystal Oscillator
EX-420
Description
The EX-420 provides exceptionally low aging rates and tight temperature stabilities in an extremely small package over a wide
range of environmental conditions. This EMXO series bridges the gap between current large, high precision OCXO’s and smaller
TCXO’s. The EX-420 Series becomes the most economical choice where there is a need for spectral purity, short and long term
stability, along with small size and dramatically reduced power consumption.
Features
•
•
•
•
•
4-Pin Half Dip
Fast Warmup
Low Power Consumption
Previous Model Number: EX-620 series
Frequency Range: 10 MHz - 30 MHz
•
•
•
•
Applications
SONET/SDH, DWDM, FDM, ATM, 3G
Telecom Transmission and Switching Equipment
Wireless Communication Equipment
Military Airborne and Mobile systems
Performance Speci cations
Frequency Stabilities
1
Parameter
vs. operating temperature range (refer-
enced to +25°C)
Min
-50
-75
-100
Typ
Max
+50
+75
+100
Units
ppb
ppb
ppb
Condition
0… +70°C
-20… +70°C
-40… +85°C
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Performance Speci cations
Frequency Stabilities
1
Parameter
vs. Stratum
3 per
GR-1244-
CORE
Operating Temp
Holdover
Drift
MTIE
Warm-up Time
Initial Accuracy
vs. supply voltage change
vs. load change
vs. aging / day
vs. aging / 1 year
Supply voltage (Standard)
Supply voltage (Option)
Power Consumption
-1
-20
-10
-2.0
-300
4.75
3.135
5.0
3.3
Min
-140
-140
-370
-4.63
Typ
Max
+140
+140
+370
+4.63
+1
1
1.5
+1
+20
+10
+2.0
+300
5.25
3.465
1.5
0.3
0.6
Units
ppb
ppb
ppb
ppb
10-13/sec
ppm
minutes
minutes
ppm
ppb
ppb
ppb
ppb
VDC
VDC
Watts
Watts
Watts
Condition
-20… +70°C
-40… +85°C
24 hours
Over 7100 seconds
0.16 sec < Observe Times < 64 sec
to ± 100 ppb of nal frequency (1 hour) @+25°C
to ± 100ppb of nal frequency (1 hour) @-40°C
xed frequency, no EFC input
VS ± 5%
Load ± 5%
after 30 days of operation
after 30 days of operation
Supply Voltage (Vs)
during warm-up
steady state @ +25°C
steady state @ -40°C
RF Output
Signal [Standard]
Load
Signal Level (Vol)
Signal Level (Voh)
Duty cycle
Signal [Standard]
Load
Output Power [Standard]
Output Power [Option]
Harmonics
Spurs
Tuning Range
Tuning Range
Linearity
Tuning Slope
±3.0
0
+3
50
+4
+7
-30
-60
0.8
40
60
Sinewave
ohm
dBm
dBm
dBc
dBc
50 Ohm load
50 Ohm load
50 Ohm load
50 Ohm load
15
0.1
HCMOS
pF
VDC
VDC
%
(Voh-Vol)/2
Frequency Tuning (EFC) 10 to 80 MHz
Fixed EMXO; No adjust
±10.0
20
Positive
ppm
%
from 0V to Vs
Additional Parameters
Phase Noise
-100
-130
-140
-145
0.2
3
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
ppb
g
10 Hz
100 Hz
1 KHz
10 KHz
Tau = 1 sec to 10 sec
Allan Deviation
Weight
Processing & Packing
Handling & processing note
Absolute Maximum Ratings
Supply Voltage
Output Load
5.5
30
VDC
pF
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Frequency Stabilities
1
Parameter
Operable temperature range
Storage temperature range
• Mechanical Shock (survive)
• Vibration Random (survive)
• Vibration Sine (survive)
• Thermal Shock (survive)
Min
-55
-55
Typ
Max
+85
+85
Units
°C
°C
Condition
Environmental Conditions
MIL-STD-202, Test Method 213, Condition E (100G, 0.5msec)
MIL-STD-202, Test Method 214, Condition I-H (20Grms, 3 minutes/axis)
MIL-STD-202, Test Method 204, Condition D (20Grms, 20 minutes/axis)
MIL-STD-202, Test Method 107, Condition A-2 (50 Cycles, -55°C to +85 °C)
Outline Drawing / Enclosure
Dimensions in mm (inches)
Type A
Code
0
Height “H”
7.62
Pin Length “L”
5.08
Type B
Code
1
2
Height “H”
8.89
9.65
Pin Length “L”
NA
NA
Pin Connections
1
2
3
4
EFC \ No Connect
Ground (Case)
RF Output
Supply Voltage Input
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Recommended Re ow Pro le
tp
T
p
Ramp up
Ts
Critical Zone
T
L
to T
p
T
L
Temperature
t
L
Ramp dow n
Ts
ts
preheat
25
t 25°C to peak
Time
Profile Feature
PRECAUTION:
Sn-Pb Assembly
Profile Feature
Sn-Pb Assembly
Series shall not expose to temperature higher than 230°C. If exposing to temperature higher than
230°C, stability and power consumption may permanently degrade.
3°C/second max.
135°c
155°c
60-90 seconds
3°C/second max.
Time within 5°C of actual
Peak Temperature (tp)
Ramp-down Rate
10-20 seconds max.
6°C/second max.
Time 25°C to Peak Temperature
Time maintained above
- Temperature (TL)
- Time (tL)
4 minutes max.
183°C
45-60 seconds
Average ramp-up rate (TL to Tp)
Preheat -Temperature Min Tsmin)
-Temperature Min Tsmax)
-Time (min to max) (ts)
Tsmax to TL - Ramp-up Rate
Time maintained above
- Temperature (TL) 183°C
- Time (tL)
45-60 seconds
Peak Temperature (Tp)
max 220°C
Note: All temperatures refer to topside of the package, measured on the package body surface.
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Ordering Information
EX - 420 0 - D A J - 107 0 - 10M0000000
Product Family
EX: EMXO
Package
13x 13mm
Height
0: A 7.62mm (HCMOS only)
1: B 8.89mm (HCMOS only)
2: B 9.65mm (Sinewave only)
Supply Voltage
D: 5 Vdc
E: 3.3 Vdc
RF Output Code
A: HCMOS
E: Sinewave
Frequency
Frequency Control
0: Fixed Frequency (HCMOS)
1: Fixed Frequency (0 dBm)
2: Fixed Frequency (+3 dBm)
3: Electrical Tuning (HCMOS)
4: Electrical Tuning (0 dBm)
5: Electrical Tuning (+3 dBm)
Stability Code
508: ±50ppb
758: ±75ppb
107: ±100ppb
147: ±140ppb(ST3)
Temperature Range
E: -40°C to +85°C
J: -20°C to +70°C
T: 0°C to +70°C
Notes:
1. Contact factory for improved stabilities or additional product options. Not all options and codes are available at all
frequencies.
2. Unless other stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency
control voltage, load, temperature (25°C).
3. Phase noise degrades with increasing output frequency.
4. Subject to technical modi cation.
5. Contact factory for availability.
For Additional Information, Please Contact
USA:
Vectron International
267 Lowell Road
Hudson, NH 03051
Tel: 1.888.328.7661
Fax: 1.888.329.8328
Europe:
Vectron International
Landstrasse, D-74924
Neckarbischofsheim, Germany
Tel: +49 (0) 3328.4784.17
Fax: +49 (0) 3328.4784.30
Asia:
Vectron International
1F-2F, No 8 Workshop, No 308 Fenju Road
WaiGaoQiao Free Trade Zone
Pudong, Shanghai, China 200131
Tel: 86.21.5048.0777
Fax: 86.21.5048.1881
Disclaimer
Vectron International reserves the right to make changes to the product(s) and or information contained herein without notice. No liability is assumed as a result of their use or application.
No rights under any patent accompany the sale of any such product(s) or information.
Rev: 11-25-2008 daf
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
测试/测量
京公网安备 11010802033920号
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved
电子工程世界
