Instruction Sheet
Tiger Eye™
Connector Series:
SFSX, S2SX, TFSX, and T2SX Series
STS-N-003
Rev. C
Date: 9/25/2014
CAT-EX-169-01 - Extraction Tool
FIGURE 1
1. INTRODUCTION
Contacts can be safely removed from a housing cavity by using the extraction tool shown in
Figure 1.
This
instruction sheet covers the use of the SAMTEC Extraction Tool CAT-EX-169-01. These tools are intended to
aid in the removal of the CC03, T1M44, CC81, and T1M82 Tiger Eye™ contacts and terminals from the
housing.
2. CUSTOMER SERVICE
Further tooling and product application assistance is available by contacting the
Samtec Application
Service Line - (+1-800-726-8329 (+1-812-944-6733))
8:00 AM to 5:00 PM eastern time. To expedite
your inquiry, have the pertinent part numbers for the product and tooling.
Page 1 of 2
This is a controlled document and is subject to change (printed versions are not controlled)
Instruction Sheet
Tiger Eye™
Connector Series:
SFSX, S2SX, TFSX, and T2SX Series
STS-N-003
Rev. C
Date: 9/25/2014
CAT-EX-169-01 - Extraction Tool
3. DESCRIPTION
Each tool handle is marked with the tooling number. Make sure it matches the tooling number specified in
this document.
The Tiger Eye™ contacts and terminals have a retaining lance that can be released through an access cavity
located on the top and bottom of the housing as shown in
Figure 2.
The Extraction tool has a tip that is
inserted into the cavity to depress the lance the correct amount for contact removal.
CAUTION -
Do not use any unintended tools to release the lance. This can cause damage to the lance and
weaken its ability to retain the reinserted contact in the housing.
4. EXTRACTION PROCEDURE
The following steps are recommended:
1.
2.
3.
Push the desired lead forward in the cavity towards the mating face. This will provide clearance for
the lance to be depressed.
From the top or bottom of the housing insert the Extraction Tool into the lance cavity as shown in
Figure 2.
This is typical for all contacts.
Maintain pressure against the locking lance then grip the lead and pull the contact from its cavity.
FIGURE 2
Page 2 of 2
This is a controlled document and is subject to change (printed versions are not controlled)
模拟电子
京公网安备 11010802033920号
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved
电子工程世界
