Datasheet> 器件分类 > 模拟混合信号IC> 信号电路> LTC5536ES6#TRMPBF

文档预览

LTC5536ES6#TRMPBF: 产品描述IC RF POWER DETECTOR TSOT23-6; 产品类别模拟混合信号IC 信号电路; 文件大小222KB，共3页; 制造商Linear ( ADI ); 官网地址http://www.analog.com/cn/index.html; 标准

下载文档详细参数选型对比全文预览

LTC5536ES6#TRMPBF概述

IC RF POWER DETECTOR TSOT23-6

LTC5536ES6#TRMPBF规格参数

参数名称	属性值
Brand Name	Linear Technology
是否Rohs认证	符合
厂商名称	Linear ( ADI )
零件包装代码	SOT
包装说明	VSSOP, TSOP6,.11,37
针数	6
制造商包装代码	S6
Reach Compliance Code	compliant
ECCN代码	EAR99
模拟集成电路 - 其他类型	ANALOG CIRCUIT
JESD-30 代码	R-PDSO-G6
JESD-609代码	e3
长度	2.9 mm
湿度敏感等级	1
功能数量	1
端子数量	6
最高工作温度	85 °C
最低工作温度	-40 °C
封装主体材料	PLASTIC/EPOXY
封装代码	VSSOP
封装等效代码	TSOP6,.11,37
封装形状	RECTANGULAR
封装形式	SMALL OUTLINE, VERY THIN PROFILE, SHRINK PITCH
峰值回流温度（摄氏度）	260
电源	3.6 V
认证状态	Not Qualified
座面最大高度	1 mm
最大供电电压 (Vsup)	5.5 V
最小供电电压 (Vsup)	2.7 V
标称供电电压 (Vsup)	3.6 V
表面贴装	YES
技术	CMOS
温度等级	INDUSTRIAL
端子面层	Matte Tin (Sn)
端子形式	GULL WING
端子节距	0.95 mm
端子位置	DUAL
处于峰值回流温度下的最长时间	30
宽度	1.625 mm

文档预览

下载PDF文档

全文
预览

QUICK START GUIDE FOR DEMONSTRATION CIRCUIT 730

7 GHZ RF DETECTOR WITH OUTPUT COMPARATOR

LTC5536ES6

DESCRIPTION

Demonstration circuit 730 is used to evaluate the

LTC®5536ES6, RF power detector with integrated

output comparator. The LTC5536ES6 has provisions

for comparator reference settings. The RF input fre-

quency range is 600 MHz to 7000 MHz. Maximum

input power is 12 dBm. The output voltage at Vout is

either logic HIGH or logic LOW. Logic LOW can be

800mV while sinking 20mA. Logic HIGH is within

0.4V of Vcc when sourcing 20mA. Vm (pin E3)

should be set for desired reference voltage (about

125mV or higher) for initial tests and measurements.

When the RF signal is applied, and depending on ref-

erence (Vm) settings, the output voltage will stay

LOW, or will go to HIGH level, typically Vcc-0.4V.

The optional R1 and R3 termination resistors, C3

output shunt capacitor and R2 pull-up resistor are not

placed on the PCB. C5 shunt capacitor (0.22 uF) at

Vm pin is used to reduce noise and voltage spikes

from power supply.

Design files for this circuit board are available. Call

the LTC factory.

LTC is a trademark of Linear Technology Corporation

QUICK START PROCEDURE

Demonstration circuit 730 is easily set up for evaluat-

ing the LTC5536ES6 RF power detector performance.

Follow the procedures outlined below and connec-

tions on the attached diagram for proper operation.

1. Connect the power supply ground to E4 or E6.

Connect the DC power supply (2.7V to 5.5V) to

E1. The typical current consumption is about

2.1mA. Connect J1 to the RF signal generator via

coaxial cable with an SMA connector. It is com-

mon practice to include a 2dB or 3dB pad to mi-

nimize reflections back into the signal generator.

2. Apply an RF input signal and measure the Vout

DC voltage at E2.

3. Set Vm (pin E3) to desired reference voltage,

125mV or higher. Connect L

(Latch Enable) pin

to ground. Increase RF input level to the point

when output voltage will go to HIGH level, typical-

ly Vcc-0.4V.

Optional measurements can be done by increasing

Vm reference level. During the measurements, when

Vout is HIGH, connect L

to Vcc. Remove the RF in-

put signal and the Vout will continue to stay HIGH.

NOTE: For timing measurements at Vm pin C5 capa-

citor (0.22 uF) should be removed.

LTC5536ES6#TRMPBF相似产品对比

	LTC5536ES6#TRMPBF	DC730A	LTC5536ES6#TRPBF
描述	IC RF POWER DETECTOR TSOT23-6	eval board for ltc5536es6
Brand Name	Linear Technology	-	Linear Technology
是否Rohs认证	符合	-	符合
厂商名称	Linear ( ADI )	-	Linear ( ADI )
零件包装代码	SOT	-	SOT
包装说明	VSSOP, TSOP6,.11,37	-	VSSOP, TSOP6,.11,37
针数	6	-	6
制造商包装代码	S6	-	S6
Reach Compliance Code	compliant	-	compliant
ECCN代码	EAR99	-	EAR99
模拟集成电路 - 其他类型	ANALOG CIRCUIT	-	ANALOG CIRCUIT
JESD-30 代码	R-PDSO-G6	-	R-PDSO-G6
JESD-609代码	e3	-	e3
长度	2.9 mm	-	2.9 mm
湿度敏感等级	1	-	1
功能数量	1	-	1
端子数量	6	-	6
最高工作温度	85 °C	-	85 °C
最低工作温度	-40 °C	-	-40 °C
封装主体材料	PLASTIC/EPOXY	-	PLASTIC/EPOXY
封装代码	VSSOP	-	VSSOP
封装等效代码	TSOP6,.11,37	-	TSOP6,.11,37
封装形状	RECTANGULAR	-	RECTANGULAR
封装形式	SMALL OUTLINE, VERY THIN PROFILE, SHRINK PITCH	-	SMALL OUTLINE, VERY THIN PROFILE, SHRINK PITCH
峰值回流温度（摄氏度）	260	-	260
电源	3.6 V	-	3.6 V
认证状态	Not Qualified	-	Not Qualified
座面最大高度	1 mm	-	1 mm
最大供电电压 (Vsup)	5.5 V	-	5.5 V
最小供电电压 (Vsup)	2.7 V	-	2.7 V
标称供电电压 (Vsup)	3.6 V	-	3.6 V
表面贴装	YES	-	YES
技术	CMOS	-	CMOS
温度等级	INDUSTRIAL	-	INDUSTRIAL
端子面层	Matte Tin (Sn)	-	Matte Tin (Sn)
端子形式	GULL WING	-	GULL WING
端子节距	0.95 mm	-	0.95 mm
端子位置	DUAL	-	DUAL
处于峰值回流温度下的最长时间	30	-	30
宽度	1.625 mm	-	1.625 mm

LTC5536ES6#TRMPBF

LTC5536ES6#TRMPBF概述

LTC5536ES6#TRMPBF规格参数

文档预览

LTC5536ES6#TRMPBF相似产品对比

推荐资源