电子工程世界电子工程世界电子工程世界

关键词

搜索

型号

搜索

177-714-2-31GS4K1-24FCN

产品描述Interconnection Device
产品类别连接器    连接器   
文件大小436KB,共4页
制造商Glenair
官网地址http://www.glenair.com/
下载文档 详细参数 全文预览

177-714-2-31GS4K1-24FCN概述

Interconnection Device

177-714-2-31GS4K1-24FCN规格参数

参数名称属性值
Reach Compliance Codecompli
连接器类型INTERCONNECTION DEVICE
Base Number Matches1

文档预览

下载PDF文档
MWDM Micro-D Shielded Cable Assemblies
Single-Ended or Double-Ended–These
easy-to-order cable
assemblies eliminate the need for expensive assembly
labor. 100% tested and ready for use.
Now With Twisted Pairs–No
need to create a procurement
specification for Micro-D cables with twisted pairs. Glenair
177-740 cables are furnished with a full complement of
white/blue twisted pair wires.
Integral Shield Termination–The
connector shell has a
platform to accept Band-It shield termination bands. The
cable shield braid is attached directly to the connector.
Save Labor, Reduce Weight and Improve EMI Shielding with
Glenair’s Micro-D Shielded Cable Assemblies
Aerospace electronics systems require higher and higher levels of protection from radiated emissions. Glenair’s fully
shielded Micro-D cable assemblies meet this need. The cable shield is attached directly onto the one-piece connector
shell and secured with a stainless steel
BAND-IT
® clamp. These pre-wired, 100% tested assemblies meet the
requirements of MIL-DTL-83513. An optional ground spring on the pin connector assures low shell-to-shell resistance.
Available with a variety of wire types and shields, Micro-D shielded assemblies can be ordered in any length, either
single-ended or “back-to-back”.
Ground Spring and EMI Shielding Effectiveness
– A gold-plated
stainless steel ground spring on the pin connector mating face offers
substantial improvement in EMI protection. The graphs compare
identical connectors tested with and without ground springs.
EMI Performance with Ground Spring
SHIELDING EFFECTIVENESS (DB)
SHIELDING EFFECTIVENESS (DB)
100
90
80
70
60
50
40
30
20
10
0
1.00E+03
100
90
80
70
60
50
40
30
20
10
0
1.00E+03
EMI Performance without Ground Spring
1.00E+04
1.00E+05
1.00E+06
1.00E+07
1.00E+08
1.00E+09
1.00E+04
1.00E+05
1.00E+06
1.00E+07
1.00E+08
1.00E+09
FREQUENCY (Hz)
FREQUENCY (Hz)
© 2006 Glenair, Inc.
CAGE Code 06324/0CA77
Printed in U.S.A.
GLENAIR, INC. • 1211 AIR WAY • GLENDALE, CA 91201-2497 • 818-247-6000 • FAX 818-500-9912
www.glenair.com
B-8
E-Mail: sales@glenair.com
关于stm32f103r8t6的定位问题!!!
本帖最后由 langmanhengxing 于 2014-7-17 17:27 编辑 我用UART-GPS-NEO-7M-C模块,通过杜邦线连接stm32f103r8t6核心板,通过串口usart GPS 定位的信息都能够通过板子传输到电脑上。(我用s ......
langmanhengxing stm32/stm8
LM3S811驱动SSD1306 OLED 程序!
驱动OLED管脚为PB2,PB3,OLED驱动芯片为SSD1306,分辨率为12864。本来是写给我老婆看的,所以大家自行更改!...
bingxuelian 微控制器 MCU
获得2MHz开关频率的四种设计技巧
设计人员必须满足汽车应用的许多电磁兼容性(EMC)要求,并且为电源选择正确的开关频率(fsw)对满足这些要求至关重要。大多数设计人员在中波AM广播频带外(通常为400kHz或2MHz)选择开关频率, ......
maylove 模拟与混合信号
关于AD转换通过串口显示
在protues仿真中,用AD0804采集数据后,直接赋给SBUF,然后通过虚拟终端显示,但是不能显示出来,该怎么写?谢谢! SBUF=P2; while(!TI); TI=0;这个是参照郭天翔那个写的 但是虚拟终端显 ......
skyman_liu 51单片机
求助avr单片机bootloader
网上的通用xmega的bootloader移植出来的,但是发送XModem并不能完成升级。求指教! #include "usart.h" #include "bootcfg.h" #include "sp_driver.h" #include "XMODEM.h" #include "LED. ......
285844685 Microchip MCU
MSP430单片机的流量检测应用分析
对于传统流量检测系统而言,其多数选用的是电磁传感器,而电磁传感器易受外界磁场的影响而导致流量计量的不正确,MSP430单片机作为一种超低功耗的16位混合信号处理器,其在流量检测中的应用得到 ......
fish001 微控制器 MCU

 
EEWorld订阅号

 
EEWorld服务号

 
汽车开发圈

 
机器人开发圈

About Us 关于我们 客户服务 联系方式 器件索引 网站地图 最新更新 手机版

站点相关: 大学堂 TI培训 Datasheet 电子工程 索引文件: 203  1507  2911  1590  1102  5  31  59  33  23 

器件索引   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

北京市海淀区中关村大街18号B座15层1530室 电话:(010)82350740 邮编:100190

电子工程世界版权所有 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号 Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved