FMC INTERCONNECT BOARD
CYUSB3ACC-005
1. Connect the EZ-USB
®
FX3
TM
SuperSpeed Explorer (CYUSB3KIT-003) to the
FMC Interconnect Board (CYUSB3ACC-005)
2. Plug the FMC Interconnect Board into the Xilinx
®
FPGA board (The Xilinx
FPGA board is not part of this kit)
3. Make sure that Jumper J5 on CYUSB3KIT-003 is open
4. Learn to use FX3 in applications involving Xilinx FPGA with the application
note
AN65974 - Designing with the EZ-USB
®
FX3
TM
Slave FIFO Interface
available at
http://www.cypress.com/go/AN65974
FMC INTERCONNECT BOARD
CYUSB3ACC-005
Note:
Please take care when removing the accessory board from the SuperSpeed
Explorer Kit board. The suggested removal method is shown in the picture
above. Hold the accessory board and use a rocking motion to separate the
boards safely
For the latest information about this interconnect board and to download the
hardware les, visit
www.cypress.com/go/CYUSB3ACC-005
For the latest information about EZ-USB FX3 SuperSpeed Explorer Kit (CYUSB3KIT-003) and to
download Kit Software and Hardware les, visit
www.cypress.com/go/SuperSpeedExplorerKit
© 2014 Cypress Semiconductor Corporation. All rights reserved.
All trademarks or registered trademarks referenced herein are the
properties of their respective owners. Doc.# 001-92305 Rev**