Smart ADAPT2 with LCD/GLCD
All Mikroelektronika’s development systems feature a large number of peripheral
modules expanding microcontroller’s range of application and making the
process of program testing easier. In addition to these modules, it is also
possible to use numerous additional modules linked to the development system
through the I/O port connectors. Some of these additional modules can operate
as stand-alone devices without being connected to the microcontroller.
™
Manual
Additional board
MikroElektronika
Smart ADAPT2 with LCD/GLCD
The Smart ADAPT2 with LCD/GLCD additional board is used to redirect signal that is sent from a pin on the development
system to a pin of another additional board or device.
Key features:
- Two input and two output ports;
- Use of LCD or GLCD display enabled;
- 3.3V or 5V power supply voltage.
Figure 1:
Smart ADAPT2 with LCD/GLCD
How to connect the board?
The additional board can be easily connected to a development system via 2x5 connectors CN1 and CN2. These
connectors are connected to the development system’s ports via a flat cable with IDC10 connectors on its ends, Figure
3. Connection with another additional board or a device is established via 2x5 connectors CN3 and CN4. LCD or GLCD
display may be connected via a 1x20 connector CN6. Potentiometer CN1 is used to adjust display contrast, whereas
the position of jumper JP2 depends on the display in use. The additional board can be supplied with the power supply
voltage (VCC) from the development system or an external power supply source (VCCIN) via the CN5 connector. The
power supply voltage (VCCIN or VCC) depends on the position of jumper JP1.
MikroElektronika
How to use the board?
In order to send a signal from I2 to O4 pin, it is necessary to place jumper over the appropriate pin on the additional
board, Figure 2. In this way, connection between I2 and O4 pins is established, which is marked with red lines on Figure
below. The same rule applies to all pins. It is necessary to follow designations next to pins supplied on the additional
board and place jumper over the appropriate ones. Several jumpers may be placed on the board at the same time.
Figure 2:
Redirection of signal
Figure 3:
Additional board connected to a development system
MikroElektronika
Figure 4:
Additional board connection schematic
MikroElektronika
Figure 5:
Dimensions of the additional board
MikroElektronika
嵌入式系统
京公网安备 11010802033920号
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved
电子工程世界
