Through Hole Lamp
Product Data Sheet
LTL1CHKEKNN
Spec No.: DS20-2001-687
Effective Date: 11/28/2003
Revision: A
LITE-ON DCC
RELEASE
BNS-OD-FC001/A4
LITE-ON Technology Corp. / Optoelectronics
No.90,Chien 1 Road, Chung Ho, New Taipei City 23585, Taiwan, R.O.C.
Tel: 886-2-2222-6181 Fax: 886-2-2221-1948 / 886-2-2221-0660
http://www.liteon.com/opto
LITE-ON TECHNOLOGY CORPORATION
Property of Lite-On Only
Features
* High luminous intensity output.
* Low power consumption.
* High efficiency.
* Versatile mounting on P.C. Board or panel.
* I.C. Compatible/low current requirement.
* 3.1 mm diameter package.
Package Dimensions
Part No.
LTL1CHKEKNN
Lens
Water
Clear
Source Color
AlInGaP Red
Notes:
1. All dimensions are in millimeters (inches).
2. Tolerance is ±0.25mm(.010") unless otherwise noted.
3. Protruded resin under flange is 1.0mm(.04") max.
4. Lead spacing is measured where the leads emerge from the package.
5. Specifications are subject to change without notice.
Part
No. : LTL1CHKEKNN
Page :
1
of
10
BNS-OD-C131/A4
LITE-ON TECHNOLOGY CORPORATION
Property of Lite-On Only
Absolute Maximum Ratings at T
A
=25℃
Parameter
Power Dissipation
Peak Forward Current
(1/10 Duty Cycle, 0.1ms Pulse Width)
DC Forward Current
Derating Linear From 65℃
Reverse Voltage
Operating Temperature Range
Storage Temperature Range
Lead Soldering Temperature
[1.6mm(.063") From Body]
260℃ for 5 Seconds
60
30
0.75
5
-40℃ to + 80℃
-55℃ to + 100℃
mA
mA
mA/℃
V
Maximum Rating
75
Unit
mW
Part
No. : LTL1CHKEKNN
Page :
2
of
10
BNS-OD-C131/A4
LITE-ON TECHNOLOGY CORPORATION
Property of Lite-On Only
Electrical / Optical Characteristics at T
A
=25℃
Parameter
Symbol
Min.
Typ.
Max.
Unit
Test Condition
I
F
= 20mA
Note 1
Note 2 (Fig.5)
Measurement
@Peak (Fig.1)
Note 4
Luminous Intensity
I
V
2θ
1/2
λ
P
λ
d
Δλ
240
680
mcd
Viewing Angle
45
deg
Peak Emission Wavelength
632
nm
Dominant Wavelength
624
nm
Spectral Line Half-Width
20
nm
Forward Voltage
V
F
2.05
2.4
V
μA
I
F
= 20mA
Reverse Current
I
R
100
V
R
= 5V
Capacitance
C
40
pF
V
F
= 0 , f = 1MHz
NOTE: 1. Luminous intensity is measured with a light sensor and filter combination that approximates the CIE
eye-response curve.
2. θ
1/2
is the off-axis angle at which the luminous intensity is half the axial luminous intensity.
3. Iv classification code is marked on each packing bag.
4. The dominant wavelength, λd is derived from the CIE chromaticity diagram and represents the single
wavelength which defines the color of the device.
Part
No. : LTL1CHKEKNN
Page :
3
of
10
BNS-OD-C131/A4
LITE-ON TECHNOLOGY CORPORATION
Property of Lite-On Only
Typical Electrical / Optical Characteristics
(25℃ Ambient
Temperature
Unless
Otherwise
Curves
Noted)
Part
No. : LTL1CHKEKNN
Page :
4
of
10
BNS-OD-C131/A4
DSP 与 ARM 处理器
京公网安备 11010802033920号
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved
电子工程世界
